Roller handle for RCBS Turret Press

Description

An Effective And Economical Roller Handle For The RCBS Turret Press
Submitted for your consideration is this roller handle that works nicely with the RCBS Turret Press.
( 3/8”-16 thread on the operating arm.”)
Prolonged use can be tiring when using the operating arm with the plastic knob. This roller handle was constructed to replace the knob for those users who would enjoy a more pleasant reloading experience. The smooth operation makes quite a difference, your hand and wrist will thank you.
While the roller handle adds an additional 2” to the overall length of the operating arm, it’s much more comfortable in addition to providing a bit more leverage. It has generous dimensions that will accommodate even a large hand.
Side clearance between the roller handle and turret is about one inch.
The U-shaped frame is made of cold rolled steel, one inch wide and after being formed, the frame is bead blasted and Parkerized along with other parts. (Manganese phosphate finish.)
The roller is made of poplar hardwood, has a smooth high gloss finish and is 1 1/4" in diameter.
The roller has a
BRASS SLEEVE
that serves as a bearing over the close fitting axle bolt and this contributes to its smooth operation.
Installation is simple, just remove the plastic knob of the loading press, install the mounting hardware of the roller handle assembly and tighten. Happy reloading!
The accompanying photos show the roller handle and an installation on an RCBS Turret Press. It’s an economical hand crafted accessory and a practical alternative to the plastic knob.
More than 1,000 roller handles have been sold on eBay and other venues.
Shipping is free to any of the 50 states by First Class Mail. Thanks for taking a look.