Primer Tube & Tools Holder for Dillon 550/650/750/1050 Bullet Trays

Description

Primer Tube and Tools Holder for Dillon Bullet Tray. Condition is New. Shipped free to the US with USPS First Class. Shipping available for Canadian customers at the eBay calculated cost.
*** !!
NOTE:
This is the tube/tools holder that snaps on top of the bullet tray only.
The bullet tray is not included
!!
**
***
!! PLEASE read the entire listing, and especially size selection information before you order!!
**
This is an improved Primer Tube Holder for the Dillon Bullet Tray(s), now with size options to fit the Square Deal, 500 Series, XL650, XL750 and Super 1050 presses.
There are size selections for Large (
Dillon 22215
) and Small (
Dillon 22214
) trays - these trays are NOT specific to press models, you may have received either one.
Use the
dimensions
below and  guides in the photos to measure your tray and ensure correct fit!
The other tube holders out there use a hard, stiff, brittle plastic that makes it difficult to place and remove the tubes, and they put the tubes high up on the case feeder rim. This one is made from a urethane-based tough and flexible plastic (these are 3D-printed parts) that makes it easy to work with and the tubes are securely held in place. Because it's lower down at the bench level, it also serves nicely for transferring a stack of primers from your vibrating primer tool (if you use one) because you can "clamp" the tube in the holder and use both hands to feed the primers from the vibrator drop tube into the primer tube.
Advantages over other designs:
Slots for for calipers and wrench, holes for Allen wrench (hex key) set
. Now, your calipers are right where you need them so you can keep watch on seating depth and COAL as you work.
Improved flexibility tube clamp design allows all 10 tube slots to be filled at the same time (no need to skip slots) - increasing the number of primers you can pre-stack from 600 to 1,000.
Improved texturing on top, making a non-slip surface.
The tube holder simply snaps firmly onto the bullet tray, no tools (or anything else) are required and no modifications to your press are needed.
Sizing:
The Dillon press models mentioned in the size selection list are typical, but some presses are known to have been shipped with the small size tray where others of the same model have the large. Please be sure you are ordering the right size tray by using the measurements provided and the photos to identify your tray! Easiest to remember, is that if the bottom is smooth, it's a LARGE tray and if the bottom is ribbed, it's a SMALL.
Large Tray Topper fits trays with dimensions:
6 3/4" L x 6 1/4" W (172mm L x 158mm W) - Smooth bottom, no ridges.
Small Tray
Topper fits trays with dimensions:
6 3/8" L x 6" W (162mm L x 152mm W) - Pronounced ridges in the bottom of the tray
I'm confident that you'll be completely satisfied with my products, if not, I offer 30-day free returns!
For other custom products for the Dillon and RCBS presses, please visit my user page!