EZ clamp; quick disconnect clamp for the Dillon 550 powder measure

Description

EZ Clamp; a quick disconnect clamp for the Dillon 550 powder measure
Replaces the Dillon powder die clamp on the powder measure. This will allow for a quick, TOOL FREE, removal or installation of the powder measure.
FOR A DISCOUNT
QUANTITY
; Use the pulldown to select your quantity, discounts apply for up to (4).
What's included;
(1) EZ clamp,
(2) springs &
(2) screws
Installation;
1. Remove the powder fail safe bar assembly.
2. Remove the existing powder die clamp and screws.
3. Insert the EZ Clamp in to the powder clamp die body.
4. Insert the springs and screws, tighten screws until flush with the EZ Clamp. Use of a "PURPLE" t
hread locker is recommended.
5. Re-install the
powder fail safe bar assembly. Reference the assembly note.
6. Always Be safe! Check your powder throw after installation and before each reloading session.
Assembly note:
If you are experiencing twisting of the powder measure, the tension of the "Failsafe Powder Rod Assembly" is too loose. Adjust the "Failsafe Powder Rod Assembly" wing nut until the spring is compressed, during the priming operation, to (1/3) to (2/3) that of the at rest spring length. This will ensure the powder measure stays properly aligned while reloading.
For other DILLON products, see my other listings.
Note:
The Dillon powder measure shown in pictures is not included.
INTERNATIONAL SALES:
Shipping will be handled using the Ebay Global Shipping Program
.
The buyer will be responsible for any and all Shipping cost, Customs or import fees as calculated by the
Global Shipping Program.
The excluded shipping locations are controlled through the
Global Shipping Program. Any
location exclusions are a result of the restrictions to your country.