8-5/8" STEEL 6 T Slotted Arbor Press ANVIL WHEEL Support Plate + 2Essential Bars

Description

This lot is the best yet.  Our CNC cut blanks are finely cut from strong 3/4" thick US made alloy steel plate that is plenty strong enough for arbor presses up to 6 ton.  Now is a great time to replace your factory cast plates - before this exceptional lot is gone.
This is a 8-5/8 inch diameter slotted replacement arbor press plate anvil wheel for 4 and 5 ton ton arbor presses. CNC cut from prime steel, NOT unknown scrap metal, NOT cast.  Will not deform under load or break when dropped.
Cast doesn't last...see last picture.
Plus 2 FREE essential Press Bars.
Great upgrade for, even new, domestic and imported arbor presses with cast anvil wheels.
This is not a "Blank"
that requires further finishing.  The edges are smoothed and lightly deburred.
The bottom is ground flat and is center drilled and a 1/4" pin
is installed.
Yes, it works fine in  1/2" hole.  Final step is to
hand smooth
all sharp corners so it is a pleasure to turn (without catching) and position the wheel  for alignment.
Four slots measure 3/4", 1", 1-1/2", 2-1/4"
This arbor press anvil wheel also makes a handy bench plate for hammering, flattening, bending, forming...
One of our happy customers wrote that she used our anvil wheel over a hole in her bench for fast, frequent local disassembly of lightly pressed bearings.
We will ship your new Anvil Wheel by FREE Priority Mail - right to  your door!  We ship every day except Sunday
Always hassle free shopping from this Top Rated eBay Seller.